Cisco 640-801 Exam eTest 2

Of the following choices, which IP address should be assigned to the PC host?
1. 192.168.5.5
2. 192.168.5.32
3. 192.168.5.40
4. 192.168.5.63
The CertKing .com network is displayed in the diagram below:

Based on the diagram above, how many collision domains are present in the CertKing .com network?
1. one
2. two
3. three
4. five
In the exhibit a part of the CertKing .com is displayed. Notice the CertKing 1 Switch and the CertKing 2 hub. Which of the devices shown can transmit simultaneously without causing collisions?
1. All hosts
2. Only hosts attached to the switch
3. All hosts attached to the hub and one host attached to the switch
4. All hosts attached to the switch and one host attached to the hub
Network topology exhibit
Study the network topology exhibit carefully, in particular the two switches CertKing 1, CertKing 2, and the router CertKing 3. Which statements are true in this scenario? Select two.
1. All the devices in both networks will receive a broadcast to 255.255.255.255 sent by host CertKing A.
2. Only the devices in network 192.168.1.0 will a broadcast to 255.255.255.255 sent by host CertKing A.
3. All the devices on both networks are members of the same collision domain.
4. The hosts on the 192.168.1.0 network form one collision domain, and the hosts on the 192.168.2.0 network form a second collision domain.
How many broadcast domains are shown in the graphic assuming only the default VLAN is configured on the switches?
1. One
2. Two
3. Six
4. Twelve
1. The subnet mask in use is 255.255.255.192.
2. The subnet mask in use is 255.255.255.128.
3. The IP address 172.16.1.25 can be assigned to hosts in VLAN1.
4. The IP address 172.16.1.205 can be assigned to hosts in VLAN1
1. 172.16.82.255
2. 172.16.95.255
3. 172.16.47.255
4. 172.16.79.255
When designing OSPF networks; what is the purpose of using a hierarchical design? (Select all choices that apply)
1. To reduce the complexity of router configuration
2. To speed up convergence
3. To confine network instability to single areas of the network
4. To reduce routing overhead
The CertKing network is shown in the diagram below:

In this diagram, OSPF is used as the routing protocol between the corporate office and the offices on the left side of the diagram. An ISDN link provides connectivity from the central corporate router to the remote sales office on the right side of the diagram. Which type of route should the corporate office use to reach the router on the right side of the diagram if the overhead on the ISDN link is to be kept to a minimum?
1. A RIP route
2. An OSPF route
3. A static route
4. A default route